Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Current »

This page describes the steps for onboarding the Non-RT RIC Control Panel to ONAP Portal. This guide assumes that the user has already deployed ONAP Portal and Control Panel using the helm charts in a Kubernetes environment. The helm chart for Control Panel can be found in the it/dep repo of OSC.

Note: The current version of Control Panel has the following limitations which must be kept in mind during onboarding:

  • There is no support for https in the Control Panel yet, so the ONAP Portal must be accessed using http (with port 30215) for the Control Panel to work.
  • The user authentication is not yet supported in the Control Panel, hence the Control Panel application must allow guest access during the onboarding process.

Login to ONAP Portal

  • Open the ONAP Portal login page at this url (if the browser changes the url to use https, change it back to http):

http://<IP-k8s-node>:30215/ONAPPORTAL/login.htm

(where <IP-k8s-node> represents the IP of any k8s node in the cluster where ONAP Portal is deployed, and it can be found using the command "kubectl get nodes -o wide")

  • Credentials for ONAP Portal: demo:demo123456!

Open ONAP Portal GUI

http://<IP-k8s-node>:30215/ONAPPORTAL/applicationsHome

Onboard Controlpanel application

  • Go to Application Onboarding, and click the button Add App.
  • Enter the details about Control Panel application (as shown below) and click the Save button.

  • Some points to note about the application details:

- Any text can be put under Application Name, Username, and Password.

- The URL represents where the Control Panel can be accessed from the user's browser. It should be set to http://<IP-k8s-node>:<exposed-nodeport-controlpanel> (currently the exposed port is 30090 but could be changed in future, check the latest value in helm chart of Control Panel).

- The Rest API URL represents where the Control Panel can be accessed from the ONAP Portal internally. It should be set to  http://<service-name-controlpanel>:<internal-port-controlpanel> (the current service name is Control Panel and port is 8080, check the latest values in helm chart).

- The boxes Active and Allow guess access must be checked.

Make Control Panel accessible on Home Page of ONAP Portal

  • Go to Application Catalog, and check the box for newly onboarded Control Panel application.

Open Control Panel application from Home Page of ONAP Portal

  • Go to Home, and click the newly onboarded Control Panel application.

  • The ONAP Portal then opens a new tab for the Control Panel application.

  • No labels