The CLAMP Control Loop Lifecycle Management uses the following system level dialogues.
1 Commissioning Dialogues
Commissioning dialogues are used to commission and decommission Control Loop Type definitions and to set the values of Common Parameters.
1.1 Commissioning a Control Loop Type Definition using the CLAMP GUI
1.2 Commissioning a Control Loop Type Definition using SDC
1.3 Setting Common Parameters for a Control Loop Type Definition
1.4 Commissioning a Control Loop Type Definition on Participants
1.5 Decommissioning a Control Loop Type Definition on Participants
This dialogue allows a Control Loop Type Definition to be decomissioned so that it can be deleted or its common parameter values can be altered.
1.6 Decommissioning a Control Loop Type Definition in CLAMP
1.7 Reading Commissioned Control Loop Type Definitions
2. Instantiation Dialogues
Instantiation dialogues are used to create, set parameters on, instantiate, update, and remove Control Loop instances.
2.1 Creating a Control Loop Instance
2.2 Updating Instance Specific Parameters on a Control Loop Instance
2.3 Updating a Control Loop Instance Version on Participants
2.5 Changing the state of a Control Loop Instance on Participants
2.6 De-instantiating a Control Loop Instance from Participants
2.7 Deleting a Control Loop Instance
2.7 Reading Control Loop Instances
3. Monitoring Dialogues
Monitoring dialogues are used to monitor and to read statistics on Control Loop Instances.