Page Comparison

Notes

1. The interface to Near-RT RIC to update the maxNbrOfConns per cell per slice (NSSAI) is also O1. Beyond Guilin, this will be updated to A1.
2. Messages in Brown are sent over O1 interface.
3. It is assumed that the Near RT-RIC shall send the initial setting of the maxNbrOfConns when a new NSSI is created, or when a new NSSAI is associated to the NSSI in a cell. This has impact in RAN-Sim. If this is not desired, then SDN-R should prepare and send this info to the CU, which will have an impact on the yang models, as well as in SDN-R.
4. The FileReady notifications and the PM data will be sent by each of the CUs, resulting in DFC fetching the file from the CU, etc. The flow diagram shows this flow (Steps 7 - 13) only for 1 CU.
5. It has to be decided whether a single Control Loop message from Slice Analysis MS shall be for:
   1. All Near-RT RICs (in this case, SDN-R has to separate out the message to be sent to each Near-RT RIC)
   2. One Near-RT RIC (i.e., for all the CUs associated to it)
   3. One CU